Norsat ATOMControl Bedienungsanleitung PDF herunterladen (Seite 17)

3 Controlling ATOM Devices

- 15 -

This chapter explains how to use ATOMControl to configure the Mute State of an ATOM

BUC or SSPA, how to configure the Digital Attenuator for an ATOM BUC, and how to

send custom commands to an ATOM device.

Controlling the Mute State

The tabbed interface in the Controls section of the ATOMControl User Interface contains

four tabs: the Device Info tab, the Mute tab, the Attenuation tab, and the Custom

Commands tab. The Mute tab can be used to monitor and control the Mute configuration

for the BUC or SSPA.

If the Mute tab is selected, then Mute Configuration monitoring will begin automatically

when the ATOMControl communication interface is successfully initialized. Monitoring is

automatically disabled when switching to a different tab, and is automatically re-enabled

when switching back to the Mute tab. Deinitializing the communication interface while

the Mute tab is selected will also disable Mute Configuration monitoring.

Figure 3 below shows the Mute tab controls:

Figure 3: Mute Tab Controls

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

Keine Kommentare

Norsat ATOMControl Bedienungsanleitung Seite 17